Saltar para:
Logótipo
Você está em: Início > Publicações > Visualização > Insights into all-vanadium redox flow battery: A case study on components and operational conditions

Insights into all-vanadium redox flow battery: A case study on components and operational conditions

Título
Insights into all-vanadium redox flow battery: A case study on components and operational conditions
Tipo
Artigo em Revista Científica Internacional
Ano
2018-02-17
Autores
Joana Leirós
(Autor)
Outra
Ver página pessoal Sem permissões para visualizar e-mail institucional Pesquisar Publicações do Participante Sem AUTHENTICUS Sem ORCID
Marta Boaventura
(Autor)
FEUP
Adélio Mendes
(Autor)
FEUP
Ver página pessoal Sem permissões para visualizar e-mail institucional Pesquisar Publicações do Participante Ver página do Authenticus Sem ORCID
Revista
Título: Electrochimica ActaImportada do Authenticus Pesquisar Publicações da Revista
Vol. 267
Páginas: 80-93
ISSN: 0013-4686
Editora: Elsevier
Indexação
Publicação em ISI Web of Science ISI Web of Science
Publicação em Scopus Scopus - 0 Citações
Outras Informações
ID Authenticus: P-00N-MYG
Resumo (PT):
Abstract (EN): This works reports the effect of operation conditions on the performance of a 25 cm(2) vanadium redox flow cell (VRFC) featuring commercial carbon felt (CF) as electrode and different commercial membranes, namely electrolyte flow rate and charge-discharge current density. The effect of electrode compression and thermal treatment was also assessed. The battery performance was evaluated based on the charge-discharge curves and average efficiencies during 20 charge-discharge cycles; the capacity fading was evaluated after 20 cycles. The limiting current was obtained through polarization curves and the ohmic resistance of the battery was obtained by electrochemical impedance spectroscopy (EIS). The electrodes yielding the highest energy efficiency (EE), ca. 85%, at 40 mA cm(-2) current density were thermally treated at 390 degrees C or 415 degrees C during 12 h under air. This result represents an improvement of more than 50% compared with the as-received electrodes. Additionally, energy efficiency increased ca. 10% when electrode compression rose from 8% to 25%. Increasing the flow rate from 37.5 cm(3) min(-1) to 150 cm(3) min(-1) EE was also enhanced from 76% to 84% at 40 mA cm(-2) The type of membrane affects the performance: a comparison between a commercial anion exchange membrane (AEM) and Nafion (R) series cation exchange membranes (CEM) showed that AEM, generally, yields higher EE than all Nafion (R) membranes tested; however, the capacity fading of AEM is much higher than CEM. The information provided in this work shows that, by tuning operational conditions and using suitable components, it is possible to increase the performance of a VRFC without additional costs.
Idioma: Inglês
Tipo (Avaliação Docente): Científica
Nº de páginas: 14
Tipo de Licença: Clique para ver a licença CC BY-NC-ND
Documentos
Não foi encontrado nenhum documento associado à publicação com acesso permitido.
Publicações Relacionadas

Da mesma revista

Voltammetric determination of paraquat at DNA-gold nanoparticle composite electrodes (2010)
Artigo em Revista Científica Internacional
Jose A Ribeiro; Catia A Carreira; Hye Jin Lee; Fernando Silva; Ana Martins; Carlos M Pereira
Underscoring the transport properties of yttrium-doped barium cerate in nominally dry oxidising conditions (2020)
Artigo em Revista Científica Internacional
Loureiro, F.J.A.; Ramasamy, D.; Ribeiro, A.F.G.; Adélio Mendes; Fagg, D.P.
The role of composition, morphology and crystalline structure in the electrochemical behaviour of TiNx thin films for dry electrode sensor materials (2009)
Artigo em Revista Científica Internacional
Cunha, LT; Pedrosa, P; Tavares, CJ; Alves, E; Vaz, F; C. Fonseca
The influence of CO on the current density distribution of high temperature polymer electrolyte membrane fuel cells (2011)
Artigo em Revista Científica Internacional
Boaventura, M.; Sander H.; Friedrich K.A.; Mendes, A.
Sweet aqueous solution for electrochemical synthesis of polypyrrole Part 2. On ferrous metals (2006)
Artigo em Revista Científica Internacional
Bazzaoui, M; José Inácio Martins; Costa, SC; Bazzaoui, EA; Reis, TC; Martins, L

Ver todas (74)

Recomendar Página Voltar ao Topo
Copyright 1996-2024 © Faculdade de Engenharia da Universidade do Porto  I Termos e Condições  I Acessibilidade  I Índice A-Z  I Livro de Visitas
Página gerada em: 2024-05-19 às 03:03:09 | Política de Utilização Aceitável | Política de Proteção de Dados Pessoais | Denúncias